GR1600EU, WSM
(Continued)
NOTE
• Do not apply the liquid gasket on the oil passage "A"
shown in the figure.
• Install the transaxle case screws (2) in the direction shown
in figure.
• Tighten all screws by the hand. Then, tighten the screws
located at the circled positions "B" first with tightening
torques. Next, tighten the remaining screws with tightening
torque.
Tightening torque
Transaxle case screw
(1) Transaxle Case (Front Side)
(2) Transaxle Case Screw
(3) Transaxle Case (Rear Side)
2-S29
TRANSAXLE
9.81 to 11.2 N·m
1.00 to 1.15 kgf·m
7.24 to 8.31 lbf·ft
F:
Front Side
R:
Rear Side
A:
Oil Passage
B:
Screws Which Tightened First
with Tightening Torque
9Y1210595TXS0046US0
KiSC issued 11, 2013 A