Kubota GR1600EU Workshop Manual page 176

GR1600EU, WSM
Assembling PTO Clutch Assembly
NOTE
• When assembling the PTO clutch assembly to the transaxle
assembly installed in the machine, refer to "(3) PTO Clutch"
on page 2-S33.
1. Place the transaxle case so that the front side faces upward.
And fix it lightly.
2. Install the ball bearing (1) with the sealed face inside as shown
in the figure.
3. Install the 24T gear (6) in the clutch case (7). Install the collar
(4) in the clutch case (7), noting its direction.
4. Install the thrust needle bearing (5), thrust collar (3) and PTO
shaft (2) in the clutch case (7) as shown in the figure.
5. Install the clutch disc and friction plate (9) and external snap ring
(8) in the spline boss (10).
6. Install the spring (11) in the PTO shaft (2). Install the spline boss
(10) which assembles the clutch disc and friction plate in PTO
shaft (2).
7. Turn the clutch case (7) clockwise while pushing spline boss
(10), and lock the spline boss (10) which assembles clutch disc
and friction plate to the clutch case (7).
8. Install the brake discs (13), (15) and friction plate (12), (14) in
the spline boss (10).
IMPORTANT
• Do not change the arrangement of the brake discs (13), (15)
and brake friction plates (12), (14).
NOTE
• Thickness of the brake friction plate 1 (12) is greater than
that of the friction plate 2 (14).
• The brake disc 1 (15) has the facing only in one side.
(1) Ball Bearing
(2) PTO Shaft
(3) Thrust Collar
(4) Collar
(5) Thrust Needle Bearing
(6) 24T Gear
(7) Clutch Case
(8) External Snap Ring
2-S26
TRANSAXLE
(9) Clutch Disc and Friction Plate
(10) Spline Boss
(11) Spring
(12) Brake Friction Plate 1
(13) Brake Disc
(14) Brake Friction Plate 2
(15) Brake Disc 1
(To be continued)
KiSC issued 11, 2013 A