GR1600EU, WSM
[3] DISASSEMBLING AND ASSEMBLING
(1) Front Axle Assembly
[4] SERVICING
Tie-rod
1. Remove the tie-rod mounting locking nut (1).
2. Remove the tie-rod (2).
Tie-rod mounting locking
Tightening torque
nut
(1) Tie-rod Mounting Locking Nut
Clearance between Center Pin Boss and Center Pin Collar
1. Measure the center pin boss (2) I.D. with a cylinder gauge.
2. Measure the center pin collar (3) O.D. with an outside
micrometer and calculate the clearance.
3. If the clearance exceeds the allowable limit, replace them.
Factory specification
Clearance between
center pin boss and
center pin collar
Allowable limit
Center pin boss I.D. "A"
Factory specification
Center pin collar O.D.
Allowable limit
"B"
(1) Front Axle Frame
(2) Center Pin Boss
4-S6
FRONT AXLE
48 to 55 N·m
4.9 to 5.7 kgf·m
36 to 41 lbf·ft
(2) Tie-rod
9Y1210595FBS0007US0
0.109 to 0.200 mm
0.00430 to 0.00787 in.
0.210 mm
0.0827 in.
25.400 to 25.430 mm
1.0000 to 1.00117 in.
25.230 to 25.291 mm
0.99331 to 0.99570 in.
(3) Center Pin Collar
9Y1210595FBS0008US0
KiSC issued 11, 2013 A