Kubota GR1600EU Workshop Manual page 52

GR1600EU, WSM
Checking Fan Drive Belt Tension
CAUTION
To avoid personal injury:
• Be sure to stop the engine and remove the key before
checking belt tension.
If the fan drive belt becomes loose, the engine may overheat.
1. To adjust, remove the right cover (1).
2. Then loosen the dynamo mounting screws (3) and move the
dynamo (2) outward to tighten the belt.
3. After adjustment, securely tighten the bolts.
Moderate belt tension:
The belt should deflect approx. 10 mm (0.39 in.) when the
center of the belt is depressed with finger pressure of 98 N (10 kgf).
IMPORTANT
• When replacing the fan drive belt, be careful not to catch it
on the cap under the water pump.
Deflection "A" Factory specification
(1) Right Cover
(2) Dynamo
(3) Dynamo Mounting Screw
G-34
GENERAL
10 mm
0.39 in.
A: Approx. 10 mm (0.39 in.)
M: "MOVE"
X: Incorrect Belt Pass
9Y1210595GEG0063US0
KiSC issued 11, 2013 A