Kubota GR1600EU Workshop Manual page 166

GR1600EU, WSM
Speed Control Plate
1. Remove the split pin (2), and disconnect the speed change
plate (1) and speed control arm (3).
2. Separate the speed change plate (1) and speed change rod (4).
IMPORTANT
• After assembling the speed change plate (1) and speed
change rod (4), be sure to adjust the speed change pedal
restriction. (Refer to "[1] CHECKING AND ADJUSTING" on
page 2-S6.)
(1) Speed Change Plate
(2) Split Pin
(3) Speed Control Arm
Universal Joint and Rear Wheel
1. Remove the universal joint mounting screw (1).
2. Disconnect the universal joint (2).
3. Block the front wheels with stopper, and lift up the frame.
4. Remove the retaining ring (3) and remove the rear wheel (4).
(When reassembling)
• Apply grease to the splines of the universal joint.
Universal joint mounting
Tightening torque
screw
(1) Universal Joint Mounting Screw
(2) Universal Joint
Separating Transmission
1. Remove the transaxle mounting screws (2).
2. Separate the transaxle (1) from the frame.
(When reassembling)
Transaxle mounting screw
Tightening torque
(2)
(1) Transaxle
2-S16
TRANSAXLE
(4) Speed Change Rod
(5) Lock Nut
9Y1210595TXS0025US0
9.81 to 11.2 N·m
1.00 to 1.15 kgf·m
7.24 to 8.31 lbf·ft
(3) Retaining Ring
(4) Rear Wheel
9Y1210595TXS0026US0
48 to 55 N·m
4.9 to 5.7 kgf·m
36 to 41 lbf·ft
(2) Transaxle Mounting Screw
9Y1210595TXS0027US0
KiSC issued 11, 2013 A