Checking, Disassembling And Servicing; Checking And Adjusting; Preparation; Separating Front Axle Assembly - Kubota GR1600EU Workshop Manual

GR1600EU, WSM

4. CHECKING, DISASSEMBLING AND SERVICING

[1] CHECKING AND ADJUSTING

[2] PREPARATION

(1) Separating Front Axle Assembly

Toe-in
1. Inflate the tires to the specified pressure.
2. Turn the front wheels straight ahead.
3. Measure the toe-in (B-A).
4. If the measurement is not within the factory specifications,
replace the tie-rod.
Toe-in (B-A) Factory specification
(A) Wheel to Wheel Distance at Front
(B) Wheel to Wheel Distance at Rear
Anti-Vibration Bolt
1. Jack up the front of machine.
2. Measure the clearance between the front axle frame (1) and
anti-vibration bolt (2).
3. If the measurement exceeds the factory specification, adjust the
anti-vibration bolt.
Clearance between front
axle frame and Factory specification
anti-vibration bolt
(1) Front Axle Frame
(2) Anti-Vibration Bolt
Dismounting Mower
1. Refer to "[2] PREPARATION (DISMOUNTING MOWER)" on
page 7-S10.
Battery
CAUTION
• When disconnecting the battery cables, disconnect the
negative cable from the battery first. When connecting,
connect the positive cable to the battery first.
1. Open the bonnet.
2. Disconnect the negative cable (1) from the battery.
3. Disconnect the positive cable (2) from the battery and remove
the battery (3).
(1) Negative Cable
(2) Positive Cable
4-S4
FRONT AXLE
1.0 to 10 mm
0.040 to 0.39 in.
(C) Front
9Y1210595FBS0004US0
0.30 to 0.50 mm
0.012 to 0.019 in.
A: Clearance
9Y1210595FBS0005US0
9Y1210595TXS0017US0
(3) Battery
9Y1210595ENS0023US0
KiSC issued 11, 2013 A