Preparation; Separation Of The Engine - Kubota GR1600EU Workshop Manual

GR1600EU, WSM

[2] PREPARATION

(1) Separation of the Engine

Draining Coolant
CAUTION
• Never open the radiator cap while operating or immediately
after stopping. Otherwise, hot water will spout out from the
radiator. Wait for more than ten minutes to cool the
radiator, before opening the cap.
1. Open the radiator drain plug (2), and remove radiator cap (1) to
completely drain the coolant.
2. After all coolant is drained, close the drain plug (2).
Capacity (with
Coolant
recovery tank)
(1) Radiator Cap
Draining Engine Oil
1. Start and warm up the engine for approx. 5 minutes.
2. Place an oil pan underneath the engine.
3. Remove the drain plug (1) to drain oil.
4. After draining, screw in the drain plug (1).
(When refilling)
• Fill the engine oil up to the upper line on the dipstick (3).
IMPORTANT
• Never mix two different type of oil.
• Use the proper SAE Engine Oil according to ambient
temperature. Refer to "4. LUBRICANTS, FUEL AND
COOLANT" on page G-9.
Engine Oil Capacity
(1) Drain Plug
(2) Oil Inlet
(3) Dipstick
1-S19
ENGINE
2.35 L
2.48 U.S.qts
2.07 lmp.qts
(2) Drain Plug
9Y1210595ENS0021US0
1.2 L
1.3 U.S.qts
1.1 lmp.qts
A: Upper Level
B: Lower Level
9Y1210595ENS0022US0
KiSC issued 11, 2013 A