Kubota GR1600EU Workshop Manual page 119

GR1600EU, WSM
Crankshaft Assembly
1. Remove the main bearing case screw 2 (1).
2. Pull out the crankshaft assembly.
(When reassembling)
• Clean the oil passage of the crankshaft with compressed air.
• Apply oil to the main bearing case screw 2 (1).
• Install the crankshaft assembly, aligning the screw hole of main
bearing case with the screw hole of crankcase.
Tightening torque Main bearing case screw 2
(1) Main Bearing Case Screw 2
1-S33
ENGINE
27 to 30 N·m
2.7 to 3.1 kgf·m
20 to 22 lbf·ft
9Y1210595ENS0048US0
KiSC issued 11, 2013 A