Kubota GR1600EU Workshop Manual page 269

GR1600EU, WSM
Adjusting Left and Right Cutting Height
1. Park the machine on level surface.
2. Wheel pressure must be correct.
3. Raise up the mower deck to the transport position.
(Also the top end.)
4. Turn the cutting height control dial (1) to the "3" position.
5. Place 51 mm (2 in.) height wood blocks under each side of the
mower deck.
Anti-scalp rollers must not rest on the wood block.
6. Lower the mower deck.
7. Adjust the left side equally.
8. Measure the heights of blade (L) and (R) from the ground
surface and calculate the difference.
9. If the difference between left tip and right tip of blade is not
within the factory specification, adjust the length of cutting
height fine tuning bolt (2).
Difference (L) - (R)
between left tip and right Factory specification
tip of blade
(Reference)
• Length of cutting height fine tuning bolt "H":
16 to 20 mm (0.63 to 0.79 in.)
(1) Cutting Height Control Dial
(2) Cutting Height Fine Tuning Bolt
(3) Lock Nut
7-S6
MOWER
Less than
6.0 mm
0.24 in.
(L) Left Blade Measurement Position
(R) Right Blade Measurement
Position
A: Blade Height
9Y1210595MOS0005US0
KiSC issued 11, 2013 A