Kubota GR1600EU Workshop Manual page 114

GR1600EU, WSM
Fuel Camshaft
1. Remove the retaining plate (1).
2. Remove the fork lever holder mounting screws (8), then draw
out the injection pump gear (3) and fuel camshaft (2) with the
governor fork assembly.
(When reassembling)
• Hook the governor spring (7) to the fork lever 2 (6) as shown in
the figure before installing the fork lever assembly to the
crankcase.
(1) Retaining Plate
(2) Fuel Camshaft
(3) Injection Pump Gear
(4) Governor Sleeve
Oil Pump and Crankshaft Gear
1. Remove the oil pump gear (6).
2. Remove the oil pump (5).
3. Remove the collar (4), O-ring (3) and crankshaft oil slinger (2).
4. Remove the crankshaft gear (1).
(When reassembling)
• Install the collar (4) after aligning the marks on the gears. (See
the figure at "Idle Gear".)
(1) Crankshaft Gear
(2) Crankshaft Oil Slinger
(3) O-ring
1-S28
ENGINE
(5) Fork Lever 1
(6) Fork Lever 2
(7) Governor Spring
(8) Fork Lever Holder Mounting Screw
9Y1210595ENS0040US0
(4) Crankshaft Collar
(5) Oil Pump
(6) Oil Pump Gear
9Y1210595ENS0041US0
KiSC issued 11, 2013 A