Kubota GR1600EU Workshop Manual page 113

GR1600EU, WSM
Idle Gear
1. Remove the external snap ring (3), the collar (2) and the idle
gear (1).
2. Remove the idle gear shaft mounting screws (4).
3. Remove the idle gear shaft (5).
(When reassembling)
• Apply engine oil to the idle gear shaft mounting screw (4). And
tighten them.
• Install the idle gear, aligning the mark (6) on the gears referring
to the photo.
Idle gear shaft mounting
Tightening torque
screw
(1) Idle Gear
(2) Idle Gear Collar
(3) External Snap Ring
Camshaft
1. Remove the camshaft mounting screws (1) and draw out the
camshaft with gear (2) on it.
(When reassembling)
• When install the camshaft, apply engine oil to the camshaft
journals.
• Apply engine oil to the camshaft mounting screws. And tighten
them.
(1) Camshaft Mounting Screw
1-S27
ENGINE
9.81 to 11.2 N·m
1.00 to 1.15 kgf·m
7.24 to 8.31 lbf·ft
(4) Idle Gear Shaft Mounting Screw
(5) Idle Gear Shaft
(6) Mark
9Y1210595ENS0038US0
(2) Camshaft Gear
9Y1210595ENS0039US0
KiSC issued 11, 2013 A