Kubota GR1600EU Workshop Manual page 180

GR1600EU, WSM
Input Shaft, 19T-2 Gear and 17T-13T Gear Shaft
1. Remove the input shaft (1).
2. Remove the intermediate shaft (2) and 19T-2 gear (3) with
collars (6) and needle bearing (7).
3. Remove the 17T-13T gear shaft (4).
NOTE
• Install the two external snap rings (5) on intermediate shaft
(2) by shifting each mating portion by 180 degrees.
(1) Input Shaft
(2) Intermediate Shaft
(3) 19T-2 Gear
(4) 17T-13T Gear Shaft
Rear Differential Gear, Drive Shaft and 11T Gear Shaft (RH, LH)
1. Remove the rear differential gear assembly (2), 11T gear shafts
(1), (6) and drive shaft (5).
2. Remove the external snap ring (3) and washer (4) from drive
shaft (5).
(1) 11TGear Shaft (LH)
(2) Rear Differential Gear Assembly
(3) External Snap Ring
2-S30
TRANSAXLE
(5) External Snap Ring
(6) Collar
(7) Needle Bearing
9Y1210595TXS0047US0
(4) Washer
(5) Drive Shaft
(6) 11T Gear Shaft (RH)
9Y1210595TXS0048US0
KiSC issued 11, 2013 A