Checking, Disassembling And Servicing; Checking And Adjusting; Disassembling And Assembling; Pedal System Component - Kubota GR1600EU Workshop Manual

GR1600EU, WSM

4. CHECKING, DISASSEMBLING AND SERVICING

[1] CHECKING AND ADJUSTING

[2] DISASSEMBLING AND ASSEMBLING

(1) Pedal System Component

Brake Pedal Free Travel
CAUTION
• Stop the engine, remove the key, and chock the wheels
before checking brake pedal.
1. Release the parking brake.
2. Loosen the lock nut (1) and adjusting nut (2).
3. Lift up the break arm (4) by the hard.
4. Tighten the adjusting nut (2) so that the top of the brake spring
(3) touches to the brake arm (4). Next loosen the adjusting nut
(2) by 3 turns.
5. Retighten the lock nut (1).
6. Make sure that the brake pedal free travel is form 15 to 25 mm.
Then, with the brake pedal completely released, push the
bypass valve of HST and ensure that the rear wheel rotates.
Brake pedal free travel
Factory specification
"B"
(Reference)
• Brake spring length "A": 73.0 to 74.0 mm (2.88 to 2.91 in.)
(1) Lock Nut
(2) Adjusting Nut
Dismounting Mower
1. Refer to "[2] PREPARATION (DISMOUNTING MOWER)" on
page 7-S10.
Removing Container
1. Refer to "[2] PREPARATION" on page 2-S10.
Battery
1. Refer to 2-S13.
Discharge Duct
1. Refer to 2-S11.
Container Base
1. Refer to 2-S11.
Seat
1. Remove two snap pins (2), (4).
2. Remove the seat (1) and snap plate (3).
(1) Seat
(2) Snap Pin
3-S4
BRAKES
15 to 25 mm
0.59 to 0.98 in.
(3) Brake Spring
(4) Brake Arm
9Y1210595BRS0016US0
9Y1210595TXS0017US0
9Y1210595BRS0005US0
9Y1210595BRS0006US0
9Y1210595BRS0007US0
9Y1210595BRS0008US0
(3) Snap Plate
(4) Snap Pin
9Y1210595TXS0019US0
KiSC issued 11, 2013 A