Kubota GR1600EU Workshop Manual page 56

GR1600EU, WSM
Adjusting Front Axle Pivot
1. Jack up the front of machine.
2. Tighten the center pin locking nut (1) with specified torque.
3. Measure the clearance between the front axle frame (2) and
anti-vibration bolt (3).
4. If the measurement exceeds the factory specification, adjust the
anti-vibration bolt.
Tightening torque Center pin locking nut
Clearance between front
axle frame and Factory specification
anti-vibration bolt "A"
(1) Center Pin Locking Nut
(2) Front Axle Frame
(3) Anti-vibration Bolt
Checking Intake Air Line
1. Check to see that hose (1) and clamps (2) are tight and not
damaged.
2. If hose (1) and clamps (2) are found worn or damaged, replace
or repair them at once.
(1) Hose
G-38
GENERAL
77.4 to 90.2 N·m
7.90 to 9.19 kgf·m
57.1 to 66.5 lbf·ft
0.30 to 0.50 mm
0.012 to 0.019 in.
A: Clearance
9Y1210595GEG0031US0
(2) Clamp
9Y1210595GEG0032US0
KiSC issued 11, 2013 A