Kubota GR1600EU Workshop Manual page 38

GR1600EU, WSM
Checking Tire Pressure
WARNING
To avoid serious injury or death:
• Do not attempt to mount a tire on a rim. This should be
done by a qualified person with the proper equipment.
• Always maintain the correct tire pressure.
Do not inflate tires above the recommended pressure.
• Inflation pressure in front tires rises quickly when using
compressed air.
CAUTION
To avoid personal injury:
• Never operate machine with a loose rim, wheel or axle.
• Whenever bolts are loosened, retighten to specified torque.
• Check all bolts frequently and keep them tightened.
 Inflation Pressure
Though the inflation pressure is factory-set to the prescribed
level, it naturally drops slowly in the course of time. Thus, check it
every day and inflate as necessary.
Front 15 × 6.00-6, 4PR
Rear 20 × 10.00-8, 4PR
(1) Ground
Checking Transmission Fluid Level
1. Park the machine on a flat surface, lower the implement to the
ground and shut off engine and remove the key.
2. Raise the operator's seat.
3. To check the oil level, draw out the dipstick (1), wipe it clean,
reinsert it, and draw it out again. Check to see that the oil level
lies between the two notches. If the level is too low, add new oil
to the prescribed level at the oil inlet. (Refer to "4.
LUBRICANTS, FUEL AND COOLANT" on page G-9.)
IMPORTANT
• If oil level is low, do not run engine.
(1) Oil Level Dipstick
G-20
Recommended Inflation
Tire sizes
Max. Pressure
100 kPa
(1.02 kgf/cm
(0.71 kgf/cm
(A) Insufficient
(B) Normal
(C) Excessive
9Y1210595GEG0009US0
A: Oil level is acceptable within this
range.
9Y1210595GEG0010US0
GENERAL
2
, 14.5 psi)
70 kPa
2
, 10 psi)
KiSC issued 11, 2013 A