Kubota GR1600EU Workshop Manual page 184

GR1600EU, WSM
 Reinstalling PTO Cover Assembly with PTO Clutch to the Transaxle Assembly installed in the machine.
Pre-Assembly PTO Cover Assembly
1. Separate the PTO cover assembly (1) and PTO clutch
assembly (3) with brake disc and friction plate (2).
2. Install the PTO cover assembly (1) in the template (7) with the
six flange bolts and nuts (6).
3. Apply there dots of liquid gasket (Three Bond 1206D or
equivalent) on the places "A" shown in figure of the brake
friction plate 1 (4).
NOTE
• Thickness of the brake friction plate 1 (4) is greater than
that of the brake friction plate 2 (5).
4. Then, attach the brake friction plate 1 to the PTO cover
assembly (1) installed in the template (7).
5. After you make sure that the brake friction plate 1 (4) is fixed to
the PTO cover assembly (1), remove the template (7) from the
PTO cover assembly (1).
IMPORTANT
• After attaching the brake friction plate 1 (4) to the PTO
cover assembly (1), do not try to move the PTO arm.
(1) PTO Cover Assembly
(2) Brake Disc and Friction Plate
(3) PTO Clutch Assembly
(4) Brake Friction Plate 1
(5) Brake Friction Plate 2
2-S34
TRANSAXLE
9Y1210595TXS0055US0
(6) Flange Bolt and Nut
(7) Template
A: Liquid Gasket Application
Portion
9Y1210595TXS0088US0
KiSC issued 11, 2013 A