Kubota GR1600EU Workshop Manual page 181

GR1600EU, WSM
Rear Differential Gear, Drive Shaft and 11T Gear Shaft (RH, LH)
1. Remove the rear differential gear assembly (3), 11T gear shafts
(1), (7) and drive shaft (5).
2. Remove the external snap ring (8) and bearing (4) from drive
shaft (5).
(When reassembling)
• When installing the bushes (2), (6) in the rear side of transaxle
case, direct the splits of bush "A" to the front side.
(1) 11TGear Shaft (LH)
(2) Bush
(3) Rear Differential Gear Assembly
(4) Bearing
(5) Drive Shaft
Rear Differential Gear Assembly
1. Remove the 42T gear mounting screws (1).
2. Remove the 42T gear (2) and differential side gear (3).
3. Remove the differential pinion shaft (6).
4. Remove the differential pinion gears (5), differential side gear
(7) and shims (4).
NOTE
• Arrange the parts to know their original position.
(When reassembling)
• Apply molybdenum disulfide (Three Bond 1901 or equivalent) to
the inner circumferential surface of differential pinion gears (5),
differential side gears (3), (7) and shims (4).
Tightening torque 42T gear mounting screw
(1) 42T Gear Mounting Screw
(2) 42T Gear
(3) Differential Side Gear
(4) Shim
2-S31
TRANSAXLE
(6) Bush
(7) 11T Gear Shaft (RH)
(8) External Snap Ring
A: Split of Bush
9Y1210595TXS0049US0
9.81 to 11.2 N·m
1.00 to 1.15 kgf·m
7.24 to 8.31 lbf·ft
(5) Differential Pinion Gear
(6) Differential Pinion Shaft
(7) Differential Side Gear
9Y1210595TXS0050US0
KiSC issued 11, 2013 A