Kubota GR1600EU Workshop Manual page 272

GR1600EU, WSM
(Continued)
11. Measure from the level surface to the bottom of the discharge
cover at point "D" as shown in the figure below. This will be
measurement (Y).
12. The difference between measurement (Y) and (X) should be
88 mm (3.5 in.)
If not, adjust be loosing the bolt and moving the Plate Discharge
Stopper.
CAUTION
To avoid personal injury:
• Make sure (Y) - (X) is not more than 88 mm (3.5 in.)
(4) Mower Cover
(5) Bent Mark Line
Adjusting the Mower Lift Stopper
The mower lift stoppers are designed to keep the balance of the
mower deck, when lifting the mower to the highest position. Make
sure that the stopper is in contact with the underside of the frame.
To adjust:
1. Lift the mower to the highest position.
2. Loosen the lock nut and adjust the stopper on left side so that
the bolt head is in contact with the underside of the frame.
3. Lower the mower deck.
4. Turn the stopper counterclockwise a half turn, and then secure
the lock nut.
(1) Mower Lift Stopper
7-S9
MOWER
(6) Plate Discharge Stopper
(7) Mower Deck Upper Surface
9Y1210595MOS0021US0
(2) Lock Nut
9Y1210595MOS0022US0
KiSC issued 11, 2013 A