Kubota GR1600EU Workshop Manual page 112

GR1600EU, WSM
Fan Drive Pulley
1. Secure the flywheel to keep it from turning.
2. Remove the fan drive pulley screw.
3. Draw out the fan drive pulley with a puller.
(When reassembling)
• Install the pulley to crankshaft, aligning the mark (1) on them.
• Apply engine oil to the fan drive pulley retaining screws. And
tighten them.
Tightening torque Fan drive pulley screw
(1) Alignment Mark
Gear Case
1. Remove the screw (1) of inside the gear case and outside
screws (6).
2. Disconnect the start spring (2) from the fork lever 1.
3. Remove the gear case (3).
(When reassembling)
• Apply a liquid gasket (Three Bond 1215 or equivalent) to both
sides of the gear case gasket (4).
• Be sure to set three O-rings (5) inside the gear case.
(1) Screw (Inside)
(2) Start Spring
(3) Gear Case
1-S26
ENGINE
98.1 to 107 N·m
10.0 to 11.0 kgf·m
72.4 to 79.5 lbf·ft
9Y1210595ENS0036US0
(4) Gear Case Gasket
(5) O-rings
(6) Screw
9Y1210595ENS0037US0
KiSC issued 11, 2013 A