GR1600EU, WSM
(2) Brake Assembly
Brake Assembly
1. Remove the lock nut (1), plain washers (2) and brake spring (3).
2. Remove the brake plate (5).
3. Remove the brake rod (4).
4. Remove the brake assembly (6).
5. Remove the external snap ring (8).
6. Pull out the brake drum (9).
(When reassembling)
• Apply liquid gasket (Three Bond 1206D or equivalent) to joint
face of the brake assembly.
• Tighten the brake assembly mounting screws (7) while pushing
up the brake arm lever (10) by the hand.
NOTE
• After assembling the brake assembly, be sure to adjust the
brake pedal free travel. (Refer to "[1] CHECKING AND
ADJUSTING" on page 3-S4.)
Brake Assembly Mounting
Tightening torque
Screw
(1) Lock Nut
(2) Plain Washer
(3) Brake Spring
(4) Brake Rod
(5) Brake Plate
3-S7
BRAKES
7.9 to 8.8 N·m
0.80 to 0.80 kgf·m
5.8 to 6.5 lbf·ft
(6) Brake Assembly
(7) Brake Assembly Mounting Screw
(8) External Snap Ring
(9) Brake Drum
(10) Brake Arm Lever
9Y1210595BRS0015US0
KiSC issued 11, 2013 A