Kubota GR1600EU Workshop Manual page 273

GR1600EU, WSM
[2] PREPARATION (DISMOUNTING MOWER)
(1) RCK42GREU, RCK42GRF
CAUTION
• To avoid personal injury:
Shut off the engine and remove the key before dismounting the mower.
Cutting Height Adjusting Dial
1. Park the machine on level ground, and stop the engine.
2. Set the cutting height adjusting dial (1) to "1" position.
3. Set the front anti-scalp rollers at the top position.
4. Lower the mower lift lever (2) and lock in the lower position.
(1) Cutting Height Adjusting Dial
Front Link
1. Pull the lever fulcrum fixing pin (2) and turn it counterclockwise
to lock.
2. Push down the link fixing lever (1).
3. Remove the front link (3) from the mower deck.
(When reassembling)
• When you attach the front link, make sure the length of the front
link.
(1) Link Fixing Lever
(2) Lever Fulcrum Fixing Pin
Rear Link and Universal Joint
1. Disconnect the rotate plate rod (1).
2. Disconnect the rear link (2) from the mower deck, pulling the
L-pins (3).
3. Disconnect the universal joint (4) from the PTO shaft.
4. Raise the mower lift lever and lock in the raised position.
(When reassembling)
• Apply grease to the spline of PTO shaft.
• Slide the universal joint back and front to make sure the
universal joint is locked securely.
• When attach the rear links, make sure the length of the rear
links.
(1) Rotate Plate Rod
(2) Rear Link
7-S10
MOWER
9Y1210595MOS0028US0
(2) Mower Link Lever
9Y1210595MOS0007US0
(3) Front Link
9Y1210595MOS0008US0
(3) L-pin
(4) Universal Joint
9Y1210595MOS0009US0
KiSC issued 11, 2013 A