GR1600EU, WSM
Transaxle Case
1. Remove the transaxle case screws (2).
2. Separate the front side of transaxle case (1).
(When reassembling)
• Apply the liquid gasket (Three Bond 1206D or its equivalent)
without any break along the sealing groove on the front side of
transaxle case: the coating width and height should be 2 mm
(0.078 in.) and 1.5 mm (0.059 in.), respectively.
• Also apply the liquid gasket on the grooves around holes "A"
shown in the figure.
NOTE
• Apply the liquid gasket thinly to both front and rear sides
only in the oil seal receiving part "B" of rear axle. Be sure
to remove extra liquid gasket therefrom if present.
(1) Transaxle Case (Front Side)
(2) Transaxle Case Screw
(3) Transaxle Case (Rear Side)
2-S28
TRANSAXLE
F:
Front Side
R:
Rear Side
A:
Liquid Gasket Application
Portion
B:
Oil Seal Receiving Part
(To be continued)
KiSC issued 11, 2013 A