Check Point Of Every 150 Hours; Check Points Of Every 200 Hours - Kubota GR1600EU Workshop Manual

GR1600EU, WSM

[4] CHECK POINT OF EVERY 150 HOURS

[5] CHECK POINTS OF EVERY 200 HOURS

Changing Mower Gear Box Oil
CAUTION
To avoid personal injury:
• Be sure to stop the engine and remove the key before
changing the oil.
1. To drain the used oil, remove the oil filler plug (1) at the mower
gear box, tilt the mower deck and drain the oil completely into
the oil pan.
2. Fill with the new oil. (Refer to "4. LUBRICANTS, FUEL AND
COOLANT" on page G-9.)
3. After filling, reinstall the oil filler plug (1).
(1) Oil Filler Plug
(2) Drain Plug
Replacing Engine Oil Filter Cartridge
CAUTION
To avoid personal injury:
• Be sure to stop the engine and remove the key before
changing the oil filter cartridge.
• Allow engine to cool down sufficiently, oil can be hot and
may cause burns.
1. The oil filter cartridge (1) must be changed every 200 service
hours.
2. Apply a slight coat of oil onto the rubber gasket of new cartridge.
3. Tighten the filter quickly until it contacts the mounting surface.
Tighten filter by hand an additional 1/2 turn only.
4. After the cartridge has been replaced, the engine oil level
normally lowers a little. Add engine oil to proper level. Check for
oil leaks around filter gasket.
IMPORTANT
• To prevent serious damage to the engine, element of
recommended type must be used. Use only a genuine
KUBOTA filter or its equivalent.
(1) Engine Oil Filter Cartridge
G-35
GENERAL
[A] RCK42GR
[B] RCK42-GR16
9Y1210595GEG0024US0
9Y1210595GEG0025US0
KiSC issued 11, 2013 A