Kubota GR1600EU Workshop Manual page 170

GR1600EU, WSM
Brake Assembly
1. Remove the brake assembly (1).
2. Remove the external snap ring (2). And pull out the brake drum
(3).
(When reassembling)
• Apply liquid gasket (Three Bond 1206D or equivalent) to joint
face of brake assembly and hydrostatic transmission thinly.
• Tighten the brake assembly mounting screws (4) while pushing
up the brake arm lever (5) by the hand.
Brake Assembly Mounting
Tightening torque
Screw
(1) Brake Assembly
(2) External Snap Ring
(3) Brake Drum
Hydrostatic Transmission Assembly
1. Remove the hydrostatic transmission assembly (1).
(When reassembling)
• Apply the liquid gasket (Three Bond 1206D or equivalent) to
joint face of the hydrostatic transmission assembly (1).
• Cover the splines of front drive shaft with thin tape to protect the
sealing lip of the oil seal.
NOTE
• When reassembling
assembly, insert the drain pipe (3) in the hole (2) surely so
as not to drop out it.
Hydrostatic transmission
Tightening torque
mounting screw
Tightening torque Oil pressure switch
(1) Hydrostatic Transmission Assembly
(2) Hole
(3) Drain Pipe
2-S20
TRANSAXLE
7.9 to 8.8 N·m
0.80 to 0.90 kgf·m
5.8 to 6.5 lbf·ft
(4) Brake Assembly Mounting Screw
(5) Brake Arm Lever
9Y1210595TXS0031US0
the hydrostatic transmission
24 to 27 N·m
2.4 to 2.8 kgf·m
18 to 20 lbf·ft
18 to 20 N·m
1.8 to 2.1 kgf·m
13 to 15 lbf·ft
(4) Hydrostatic Transmission Mounting
Screw 2
9Y1210595TXS0032US0
KiSC issued 11, 2013 A