Kubota GR1600EU Workshop Manual page 39

GR1600EU, WSM
Checking Coolant Level
CAUTION
To avoid personal injury:
• Be sure to stop the engine and remove the key before
checking coolant level.
• Do not remove the radiator cap when the engine is hot.
Loosen cap slightly, to the stop, to relieve any excess
pressure before removing cap completely.
Check the coolant level daily both the radiator and the recovery
tank (4) before starting engine.
1. Remove the radiator cap (1) and check to see that the coolant
level is just below the fill port.
2. Check to see that the coolant level is between the "FULL" and
"LOW" marks of recovery tank (4).
3. When the coolant level drops due to evaporation, add water
only up to just below the fill port of the radiator and the full level
of the recovery tank (4).
In case of leakage, add coolant and water in the specified
mixing ratio up to the full level. (Refer to G-41.)
IMPORTANT
• If the radiator cap has to be removed, follow the caution
above and securely retighten the cap.
• Use clean, distilled coolant and water to fill the radiator and
recovery tank.
(1) Radiator Cap
(2) Overflow Pipe
(3) Recovery Tank Cap
(4) Recovery Tank
G-21
GENERAL
A: FULL
B: LOW
9Y1210595GEG0011US0
KiSC issued 11, 2013 A