Disassembling And Assembling; Starter - Kubota GR1600EU Workshop Manual

GR1600EU, WSM

[2] DISASSEMBLING AND ASSEMBLING

(1) Starter

1. Disconnect the connecting lead (7).
2. Remove the magnetic switch (5).
3. Remove the rear end frame (9).
4. Remove the brush (11) from the brush holder (12).
5. Remove the brush holder (12).
6. Draw out the yoke (6) from the starter drive housing (3).
7. Draw out the armature (16) with the drive lever (4).
NOTE
• Do not cause damage to the brush and commutator.
(When reassembling)
• Apply grease to spline teeth of the armature, bushing, pinion gear of the overrunning clutch and armature shaft.
Tightening torque C terminal nut
5.9 to 11 N·m
0.60 to 1.2 kgf·m
4.4 to 8.6 lbf·ft
6-S22
ELECTRICAL SYSTEM
(1) Sleeve Bearing
(2) Bushing
(3) Starter Drive Housing
(4) Drive Lever
(5) Magnet Switch
(6) Yoke
(7) Connecting Lead
(8) Through Bolt
(9) Rear End Frame
(10) Bushing
(11) Brush
(12) Brush Holder
(13) Brush Spring
(14) Brush
(15) Washer
(16) Armature
(17) Overrunning Clutch
9Y1210595ELS0037US0
KiSC issued 11, 2013 A