Cannot Transmit - Muratec mfx-2200 User Manual

Status
A document often
jams
The contents
registered for the
time or speed dials
disappear
The cover will not
be closed

Cannot transmit

Status
Cannot transmit
Documents are
not transmitted
continuously
9-28
DB2-90290-60.indb 28
Check item
Check if an appropriate
document is used.
Check if the document guide is
aligned properly.
Check if a piece of paper is not
left in the ADF.
Check if the document feeder
roller is clean.
Check if you do not turn off the
power and leave the machine
for a long time, or turn off the
machine everyday.
Check if you are not pressing
only one side of the cover.
Check item
Check the transmission
procedure.
Check if the destination
number is correct.
Check if an error message is
not displayed.
Check if an external dialing
number is included.
Check if there is nothing wrong
with the other machine.
Check if the documents are
loaded with the top edges
aligned.
Check if the loaded documents
do not include pages smaller
than the minimum width (120
mm).
Countermeasure
Use the appropriate document. 1-59
Align the document guide
along the document.
Open the ADF cover and
document tray, and check.
Clean the document feeder
roller.
The batteries that hold
registered contents may have
died. Please contact your
authorized Muratec dealer.
Press both sides of the cover to
close it.
Countermeasure
Check the procedure and try
again.
If you are using the speed
dial, make sure the number is
entered correctly by printing
out the list.
Take the countermeasure
following the error message.
Check if the external dialing
number is included when you
call from the extension to
external line.
Ask the other party to prepare
the machine for reception.
(Power, paper, etc.)
Reload the documents.
Load these pages on the
document glass and keep
separate from other pages.
Reference
page
1-60
9-16
9-11
9-35
—
Reference
page
3-5
8-11
9-23
—
—
1-60
2007/02/02 12:34:25