Redial; Manual Redial; Auto Redial - Muratec mfx-2200 User Manual

Redial

Fax Ready Fax Mode
2 Apr 2007 13:30 Memory:100%
Resol. Contrast ScanSize
Normal Normal
3-12
DB2-90290-60.indb 12

Manual redial


The destinations for the last 10 fax transmissions and phone calls are stored
in the machine's memory.
1
Press <Fax>.
2
Load your document.
3
Press the upper cursor key.
Auto 1/2 4
Select the destination using the cursor keys and press [Enter].

Redial

01:0751234567
02:0666667777
03:0792111111
Close
5
Press <Start>.
Scanning the document starts.
NOTE
• Numbers dialed using the numeric keys on the handset will not be memorized.
• Up to 40 digits of the dialing number per one transmission can be memorized.

Auto redial


If the other party's line is busy or if there is no answer, the machine waits
one minute (or three minutes in some countries), then tries to dial the same
number again. The machine will attempt the redial up to two times.
Fax Ready
2 Apr 2007 13:30 Memory: 99%
Resol. Contrast
Normal Normal
• The number is not automatically redialed in the manual transmission.
• W hen the auto redial is standby, the "Redial" message is displayed on the
screen.
• Y ou can change the number of times the machine attempts to redial and
the time interval the machine waits between redialing attempts.
For details on settings, refer to "Other Settings" (page 8-17) in the fax-
related settings.
• T o cancel the auto redial, press <Job Confirm./Fax Cancel> to delete the
reserved command. For details on canceling the communication, refer to
"Canceling/Checking Fax" (page 3-21).
1/4
Enter
Redial
ScanSize
Auto 1/2
2007/02/02 12:32:42