R: Reception Errors
Error
Mode
codes
R.1.1
R.1.2
R.1.4
R.1.5
R.2.3
R.3.1
R.3.3
R.3.4
R.4.2
R.4.4
R.5.1
R.5.2
R.8.1
9-22
DB2-90290-60.indb
22
Description of code
Your machine is set to manual
reception or transfer reception
and is ready to receive, but no
signal comes from the sending
party
Your machine's mode does not
match with the sending party's
Junk fax is received when the
junk fax block function is on
(only displayed in the auto print
journal)
Transmission is canceled during
the polling reception (only
displayed in the auto print
journal)
Due to a line error, communication
failed
Due to a line error, the line is
disconnected
A document was pulled out
or <Stop> was pressed by the
sending party
Due to a line error, the signal cut
off during reception (due to line
error)
Reception is not available even at
the slowest speed (due to a line
error)
The signal cut off during reception
(due to line error)
Memory overflow (only displayed
in the auto print journal)
The signal cut off during reception
The sending party pressed <Stop>
The signal cut off during reception
(due to line error)
Your machine's mode does not
match with the other machine's
Countermeasure
T he sending party may operate
incorrectly. If you know who the sending
party is, ask him/her to resend the
document.
I f you know who the sending party is,
ask him/her to resend the document.
I f this error occurs repeatedly, contact
your authorized Muratec dealer.
I f you know who the sending party is,
ask him/her to resend the document.
I f you know who the sending party is,
ask him/her to resend the document.
If this error occurs repeatedly, contact
your authorized Muratec dealer.
I f this error occurs repeatedly, contact
your authorized Muratec dealer.
I f you know who the sending party is,
ask him/her to resend the document.
If this error occurs repeatedly, contact
your authorized Muratec dealer.
C heck the other machine. The other
party may not have a document, for
example, in polling.
2007/02/02
12:34:24