Muratec mfx-2200 User Manual page 347

Error
Mode
codes
T.3.1
T.3.2
T.4.1
T.4.2
T.4.4
T.5.1,
T.5.2,
T.5.3
T.8.1
DB2-90290-60.indb 21
Description of code
In a consecutive transmission,
the pages from the second page
caused a read error
A document of which length
is longer than 900 mm was
transmitted
Brightness in the lamp is
insufficient if "Lamp error. Call
for service" is displayed after
transmission is interrupted
Due to a line error, communication
failed.
Due to a line error, the receiving
party disconnected the line during
document transmission
An image quality error occurred
at the receiving party (due to line
error)
The line is disconnected during
transmission (due to a line error)
The line is disconnected during
transmission (due to a line error)
The reception mode does not
match
Countermeasure
R esend the document starting from the
page that caused the error.
C ut the length of a page into 900 mm or
less, and resend.
T urn the power from OFF to ON and try
to copy.
If the "Lamp error. Call for service"
message is not displayed, resend the
document. If the same message is
displayed even when you copy, contact
your authorized Muratec dealer.
R esend the document. If this error occurs
repeatedly, contact your authorized
Muratec dealer.
R esend the document. If this error occurs
repeatedly, contact your authorized
Muratec dealer.
A ll pages were received but some of them
might have a poor image quality. Ask the
receiving party to check the quality of
the document.
R esend the document.
R esend the document. If this error occurs
repeatedly, contact your authorized
Muratec dealer.
C heck the other machine. The receiving
party may not use a fax machine.
Troubleshooting
9
9-21
2007/02/02 12:34:23