Displayed Messages - Muratec mfx-2200 User Manual

Displayed messages

An operation mistake or a device error is displayed on the screen. Following a
displayed message, take an appropriate action.
Error message
30 locations can be input
ADF is unavailable
Set doc. on the FBS glass.
ADF used in the
command.
Already Stored.
Auto size detection failed! When the paper selection or the magnification is set to
Box In Use
Call for service
Cannot combine with __
Carriage Error
Casset.1 has been selected If you set the magnification setting to auto, or set the
Cassette paper size error
Check direction and paper
size
Close Scanner Cover
Close the cassette
Command is full
Communication Error
DB2-90290-60.indb 23
Countermeasure
You tried to directly enter 30 or more destinations
using the numeric keys for the broadcast transmission.
A document is loaded on the ADF for the series copy.
This setting is available using the document glass only.
Load the document on the document glass.
Real time transmission has been reserved. Wait until
the real time transmission ends or cancel the command
for the real time transmission.
The same number has been already entered.
auto, a document size was not automatically detected.
Press <Start> to copy the paper displayed on the
screen in 100% maginification.
Press <Stop> to cancel copying.
An F-code box is now used for communicating, or
printing etc.
A failure occurs inside the machine. Please contact
your authorized Muratec dealer.
You are trying to combine the functions which cannot
be set simultaneously.
A scanner device has a failure. Please contact your
authorized Muratec dealer.
advanced copy that requires the auto magnification
with the paper selection set to auto, the 1st cassette
will be selected with priority.
When printed on the cassette paper, the paper size
you specified did not match the actual paper size. Or, a
paper jam may occur because more than one sheets of
paper are fed. Check a paper jam does not occur.
Set the correct paper size, or reload the paper and
press [Close].
The ADF cover is open when transmission starts. Close
the ADF cover securely.
The specified cassette is pulled out. Be sure to close the
cassette.
The number of reserved commands has exceeded
100. Wait until the reserved communications end, or
perform the real time transmission.
A communication error occurred.
Check the contents of the communication error and
repeat the operation.
Troubleshooting
Reference
page
4-3
2-19
3-14
—
2-2
9
—
9-35
2-50
9-35
—
1-46,
9-13
—
—
—
9-18
9-23
2007/02/02 12:34:24