Error codes
D: Dialing Errors
Error
Mode
codes
D.0.1
Transmission and reception
occurred simultaneously.
D.0.2
Receiving line is busy
D.0.3
<Stop> was pressed
The receiving fax number is not
D.0.6
registered when using the auto-
dial function
The receiving party did not
D.0.7
answer when using the auto-dial
function
A dial tone cannot be detected.
D.0.8
T: Transmission Errors
Error
Mode
codes
Wrong number (receiving party
answered and hung up)
The receiving party answered
T.1.1
manually and hung up the phone
The other machine is not a G3
machine
Transmission is canceled when
starting the communication
T.1.4
(only displayed in the auto print
journal)
The line status was bad
(especially when communicating
overseas) and the receiving party
cut off the line
T.2.1
Your machine's settings do not
match with the other machine's
Your machine's settings do not
T.2.2
match with the other machine's
9-20
DB2-90290-60.indb
20
Description of code
Description of code
Countermeasure
Resend the document.
Resend the document.
Resend the document.
S et the correct fax number and then
resend the document.
S et the correct fax number and then
resend the document.
C heck the line cable is connected
properly.
Check the dial tone detect settings.
Countermeasure
C heck the correct fax number and resend
the document.
C heck the receiving method on the other
machine.
T his machine cannot communicate with
it.
R esend the document.
R esend the document. If this error occurs
repeatedly, contact your authorized
Muratec dealer.
C heck the settings on the other machine.
If the receiving party has special
settings, ask him/her to release them.
C heck the model and setting status on
the other machine.
2007/02/02
12:34:23