Muratec mfx-2200 User Manual page 366

10-4
DB2-90290-60.indb 4
511 Other Settings
page 8-17
You can register a passcode required for the
closed transmission and reception.
page 6-7
ID check Tx
If you set this to ON, the lower four digits of
the fax number you dialed are compared with
those registered in the other machine, and
faxes will be transmitted only when the
numbers match.
Check broadcast dest. page 6-10
If you set this to ON, the screen for confirming the entered
destination number appears before starting transmission.
Dial double-push page 6-12
If you set this to ON, the screen for re-entering the
fax number, which was entered using the numeric
keys, appears before starting transmission.
Security Rx page 6-14
This allows documents received after the
security reception start time to be stored in
memory without being printed.
5113 # Of Redials
You can set the number of redial attempts that
will be carried out when the other line is busy.
5115 Redial Interval
You can set the redial interval.
5117 Block Junk Fax
You can block unnecessary fax reception. You
can register three modes to block faxes, and
also change or delete the registered contents.
5119 # Of Rings
When the reception mode is in fax mode or
tel/fax mode, you can set the number of rings
before fax reception starts.
5121 Dialing Pause
You can set the default dialing pause when
you enter the pause symbol.
5123 High Resolution
You can set the default value for the Super
Fine (S-Fine) setting of the [Resol.] on the
touch panel display.
5125 Rx Reduc. Rate
You can set the print reduction rate for
received documents.
5127 Reduc. Margin
When the received document will not fit in the
printing area, you can set values that
determine whether to cut off an edge or reduce
the contents to fit onto one sheet.
5129 Paper Saving
You can set the printing method for received
documents.
5133 Rotate Tx
If you set this to ON, A4
rotated to A4 for scanning and transmitted.
5135 Quick Memory Tx
If you set this to ON, fax transmission for
multiple documents starts in the order of
pages that can be scanned and stored.
5137 ECM Mode
If you set this to ON, any part of a document
that could not be transmitted correctly due to
a line error will be automatically resent.
5139 Service Mode
Do not set.
5141 Dial Prefix
You can put a number registered before a
destination number for dialing.
5143 OB transmission setup*1
You can collectively switch ON or OFF the
OfficeBridge received fax forwarding function.
documents can be
2007/02/02 12:34:31