Performing the closed transmission
• F or manual transmission, even if you set the closed transmission to ON,
it remains invalid. Documents will be transmitted even if the destination
machine is of another brand, or the passcodes are different.
• I f the display is not in the fax mode, press <Fax> to switch to the fax mode.
• B y registering "Closed Tx" to a touch panel key (page 8-52) or soft key (page
8-50), you can easily set the closed transmission to ON/OFF per transmission.
When the closed transmission is set to ON
• W hen the closed transmission is set to "On", you can perform the closed
• You can set the closed transmission " Off" only for one transmission by the
When the closed transmission is set to OFF
1
2
3
4
5
6
DB2-90290-60.indb
3
transmission normally.
procedure below.
Load your document and press <Fax>.
For details on how to load documents, refer to "Loading Documents"
(page 1-59).
Set the resolution and contrast as necessary.
For the setting procedure, refer to "Setting the resolution/contrast" (page
3-13).
Press <Menu>, select "Closed Tx" using the cursor keys, and press
[Enter].
Fax
Group
Cover Page
Security Rx
Closed Tx
ID check Tx
Delayed Tx
Settings
Close
Select "On" using the cursor keys and press [Enter].
Closed Tx
Off
On
Cancel
Press [Close].
Enter the destination fax number and press <Start>.
The closed transmission starts. After the document is scanned, the
closed transmission setting is returned to "Off".
1/4
Enter
Enter
6
6-3
2007/02/02
12:33:33