Error Codes - Muratec MFX-1450 User Manual

Muratec mfx-1450: user guide
Hide thumbs Also See for MFX-1450:
Table of Contents

Advertisement

Error codes

Dialing errors
D.0.3,
D.0.8
D.0.2
D.0.6,
D.0.7
Reception errors
R.1.1
R.1.2
R.1.4
R.2.3
R.3.1
R.3.3
R.3.4
R.4.1
R.4.2
R.4.4
R.5.1,
R.5.2
R.8.1
R.8.10
R.8.11
Transmission errors
T.1.1
T.1.4
T.2.1
T.2.2
T.2.3
DA7-909H0-60.indb
23
The remote unt ddn't respond, the call couldn't be completed or [Stop]
was pressed whle dalng. Re-try the call. If your machne repeats the
message, call the remote fax unt's operator and verfy that unt s oper-
atng properly.
The remote unt s busy. Try the call agan.
Ether the remote unt ddn't respond, the call somehow ddn't go
through or [Stop] was pressed whle dalng. Try the call agan.
The callng fax machne ddn't respond to your fax machne. Ths can
happen f someone dals a wrong number or f the remote machne
restrcts access through use of a passcode.
The two fax machnes were ncompatble. Your machne sends and
receves only ITU-T Group 3 fax communcaton, the ndustry standard
snce the early 1980s.
[Stop] was pressed on the recevng fax machne.
Poor phone lne condtons made fax communcaton mpossble. Call
someone at the remote machne's locaton.
The sendng fax machne detected too many errors from the recevng
fax machne.
The sendng fax machne s ncompatble or had a document feeder prob-
lem durng transmsson.
Poor phone lne condtons may have prevented your fax machne from
properly prntng some or all of the pages t receved.
The machne receved too much data, overloadng the memory.
Ether the lne dsconnected before transmsson or the transmttng fax
machne needs mantenance.
The machne has reached ts memory capacty.
ECM recepton faled (perhaps due to lne nose).
A compatblty error occurred.
Lne nose or other problems prevented lne probng.
The fax machne tmed out whle watng for the retran sgnal.
The remote fax machne ddn't respond to your machne. Call someone at
the remote machne's locaton.
[Stop] was pressed durng transmsson.
Ether the phone lne dsconnected durng transmsson or fax commun-
caton became mpossble due to bad phone lne condtons. Try the call
agan.
The two fax machnes were ncompatble. Your machne sends and
receves only ITU-T Group 3 fax communcaton, the ndustry standard
snce the early 1980s.
Bad phone lne condtons made fax communcaton mpossble. Cond-
tons can change rapdly, so try the call agan later.
t
11-23
rouBlEShooting
1
2
3
4
5
6
7
8
9
10
11
12
13
AI
2007/04/26
20:15:14

Advertisement

Table of Contents
loading

This manual is also suitable for:

F-525Mfx-2050F-565

Table of Contents