Transmission Errors - Muratec F-315 Field Engineering Manual

R.8.1 A compatibility error occurred.
R.8.10 Line noise or other problems prevented line probing.
R.8.11 The fax machine timed out while waiting for the retrain signal.

Transmission errors

T.1.1 T1 time-out. The remote fax machine didn't respond to your machine. This usually occurs
during a manual transmission or when an incorrect number was dialed. Call someone at
the remote machine.
T.1.4 Someone pressed <Stop> during fax transmission.
T.2.1 CFR or FTT was not received from the remote machine. Either the phone line
disconnected during fax communication or transmission became impossible due to bad
phone line conditions. Try the call again. It may be necessary to increase the output
levels on Memory switch 11 switch 0~3. The receive machine may also have closed
network or block junk fax enabled.
T.2.2 The two fax machines were incompatible. No mailbox at receiver or security transmission
is enabled.
T.2.3 FTT was received from the remote machine at 2400 bps. Bad phone line conditions made
fax communication impossible. Conditions can change rapidly, so try the call later. Turn
on the echo protect tone on Memory Switch 10 switch 4. Also adjust the interval between
DCS and TCF on Memory Switch11 switch 4 and 5. If the problem persists, try increasing
the output levels on Memory switch 11 switch 0~3.
T.3.1 The page counter in the fax machine detected a document feeder error during
transmission. Carefully re-insert the document into the feeder and re-try the call.
T.4.1 No response to MPS/EOP/EOM. Poor phone lines caused the receiving unit to
disconnect. Adjust the interval between CFR and data on Memory Switch 11 switch6 and
7. Try increasing the output levels on Memory switch 11 switch 0~3. It may also be
necessary to adjust the transmit speed on Memory Switch 10 switch0~3.
T.4.2 RTN was received from the remote machine. After transmission began, poor line
conditions developed. Try the call again. Attempt the solutions described for the T.4.1
error.
T.4.4 Poor line conditions prevented transmission. PIP was received. The transmission was
interrupted by the call mode. The receiving unit may be experiencing problems. Try the
call again.
T.5.1 No response to RR from the remote machine. Line noise or other problems prevented
ECM transmission. Increase the ECM response time on Memory Switch 01 switch2.
T.5.2 No response to CTC. Line noise or other problems prevented ECM transmission.
Increase the ECM response time on Memory Switch 12 switch 3.
T.5.3 EOR was received from the remote unit but further transmission was not possible. Adjust
Memory Switch 15 switch 0 for this problem.
T.8.1 A compatibility error occurred.
T.8.10 Line noise or other problems prevented line probing.
T.8.11 The remote fax machine didn't complete the equalizer training phase.
4-20