Panasonic KX-TD500 System Reference Manual page 887

5.00 OUS (Out of Service)
Description
Allows you to change the status of shelves, cards
and ports from "In Service" to "Out of Service" as
shown below after pressing the COMMON (F1)
key.
1 SHOW LV 2 CHG LV 3 4 INS
Operation
<Example>
Changing the status of the station (physical number
21408) from "In Service" to "Out of Service".
1. Press the F5 key.
CMD > Out of Service No.=
1 2 3 4
2. Enter the physical number of the station "21408".
2 1
COMMON > Out of Service No. = 21408
1 2 3 4
3. Press the RETURN key.
CMD > Out of Service No. = 21408
1 2 3 4
• " * * * * * OK" appears when the station
(physical number 21408) becomes "Out of
Service".
5 OUS 6 REMOVE 7 EXIT 8
F5
5 6 7 EXIT 8
4 8
0
5 6 7 EXIT 8
RETURN
5 6 7 EXIT 8
Conditions
The system should be in on-line communication
mode.
Devices to be changed to "Out of Service" and
their entry numbers are as same as that of "In
Service". Refer to Section 8-J-4.00 "INS (In
Service)".
When setting the shelf or card to "Out of Service",
their lower device such as stations & ports
become "Out of Service" simultaneously.
If it is impossible to set "Out of Service", one of
the following error messages appears on the
screen.
A type of error message depends on the situation.
*****Error : Illegal parameter
*****Error : No installed
*****Error : Diagnostic failure
*****Error : Invalid status
For details about the error messages, refer to
Section 10-K "Error Message Tables".
To repeat the "Out of Service" operation, repeat
from STEP 2.
To return to COMMON mode, press the EXIT (F7)
key.
8-J-7