9.05 Checking/Clearing the
Charge Meter–ATT
Used to check and clear the charge meter of
each ATT console.
Operation
1. Set Charge Management
Mode.
2. Enter "1".
3. Enter "1" (ATT 1)or "2"
(ATT 2).
4. Press SELECT to check the
rate.
• To alternate between the rate
and the meter, press SELECT.
To reset the meter:
5. Press CLEAR.
To check/clear another ATT:
6. Press MEMORY to store the
data.
7. Press NEXT.
To finish the programming:
8. Press END.
Display/Indicator/Tone
•
Charge Meter
•
ATT No.?
<Example>
ATT1: 00005
<Example>
ATT1: 00005
ATT1: 00001.15DM
<Example>
ATT1: 00000
• The MEMORY indicator lights
red.
<Example>
ATT2: 00020
•
SYS–PGM No?
Initial Display of PITS Station
Programming Mode.
13-C-42
Comment/Note
• Refer to Section 13-C-9.02
"Entering Charge Management
Mode".
• You can press NEXT to go to
the lowest directory number.
• The value of rate is valid only
the last 7 or 8 figures. Refer to
Section 11-C-58.02 "Charge
Rate (RAT)" for further
informations.
• Repeat steps 4 through 5.