Panasonic KX-TD500 System Reference Manual page 1262

2.00 Error Messages Related to
the Assigning Items in the
Other Commands
If there is a wrong entry related to the assigned
by the other commands, the following appears on
the message line when storting the entry: "DATA
ERROR (xxx)".
DATA ERROR No.
300 Setting DN which is not stored in the hundred
block.
301 Specified extension DN is not stored.
302 Telephone type of the extension paired with
DSS console is not PITS.
310 Setting DN to the DSS console.
320 Setting trunk group except DID on CO-line on
DID card. Or, assigning trunk group of DID to
CO-line on the card except DID.
330 Tenant is different.
331 As assigned to the destination of 1 : N of trunk
group, impossible to change tenant.
332 As assigned to the destination of doorphone
call, impossible to change tenant.
333 Attempting to assign the UCD group and the
PAG group of the different tenant to the same
pickup group.
334 Changing tenant of UCD/PAG group without
canceling extensions.
335 As assigned to the destination of paging from
attendant console, impossible to change Tenant.
336 As assigned to call placing mode of Trunk
group, impossible to change Tenant.
337 As assigned to night answer point for CO-line,
impossible to change Tenant.
338 Attempting to change the tenant of Trunk group
without removing the CO lines which belong to
the trunk group.
339 Attempting to change the tenant of Trunk group
without canceling the setting of 1:N destination
for the trunk group.
340 Deleting is impossible because it is assigned in
another item.
The (XXX) indicates an error message number
shown below and possible causes of the errors
and countermeasures for them are as follows.
Probable Cause
11-D-2
Countermeasure
Enter data in hundred block. Or, set DN
which is stored in hundred block.
Store the extension DN.
Paired extension should be changed to a
PITS.
Set DN to assignable port.
Assign trunk group to the correct kind of
card.
Assign the same tenant.
Cancel the 1 : N destination.
Cancel the doorphone call destination.
Assign the UCD group and the PAG group to
the same tenant.
Change after canceling extensions.
Impossible to move extensions to the other
tenant.
Change the destination of attendant paging.
Change assigning of incoming mode.
Change assignment of night answer point.
Change after removing the CO lines.
Impossible to move CO lines to the other
tenant.
Change after canceling 1: N destination.
Change the item beforehand.