Panasonic KX-TD500 System Reference Manual page 1041

Description of Assigning Items
PICK (01 to 32)
UCD
PAG
Conditions
If "System-Operation (1/3)", Tenant Service is set to "Yes", "Group-UCD/Paging
Group" setting must be done before setting this screen.
When assigning a pickup group to an UCD group or/and a paging group, the tenant
of the two/three groups must be the same.
An UCD group and a paging group is composed of multiple pickup groups.
When changing UCD group or paging group
All of the extensions which belong to the current and newly entered UCD groups
cannot be used. If any line is used, "**** Waiting" is displayed. In this case, wait
until all of the extensions are not in use or cancel the waiting mode by pressing the
CTRL + C keys simultaneously. Then try again during a slower period.
This restriction is only for On-line programming, not for Off-line programming.
Relation between groups
The relation between groups (trunk group, UCD group, paging group and pickup
group) is summarized on next page.
Function
The following functions appear on the function line of this setting screen.
1 COMMON 2
COMMON (SHOW LV, CHG LV, INS, OUS, REMOVE, EXIT) and HRD CPY keys
are available in this setting screen.
For operation, refer to Section 8-I "Operation of Function Keys".
Assigns the UCD (Uniform Call Distribution) group number which the call
pickup groups belong to. UCD Group is comprised of more than one pickup
group.
Assigns the paging group number which the call pickup groups belong to.
Paging Group is comprised of more than one pickup group.
3 4 5 6 HRD CPY 7
10-E-17
8