Panasonic KX-TD500 System Reference Manual page 1280

1.00 Entering/Exiting PITS System Programming Mode
1.01 Entering PITS System Programming Mode
Procedures for setting the PITS system programming mode :
Operation
1. Slide the MEMORY switch at
the rear of APITS to
"PROGRAM".
SET• • PROGRAM
MEMORY
• In the case of DPITS, push
the PROGRAM button.
2. Dial "R#" (program number).
3. Dial the PITS Programming
Password: (four digits).
When nothing is entered within one minute after "Initial display for PITS system programming mode" is
displayed, "Initial display for PITS station programming mode" is displayed again.
Result
• The following message is
displayed:
PITS-PGM No?
• The MEMORY button
indicator lights in red.
• The PITS programming
password entry screen
appears on the display:
ENTER PASSWORD
• The MEMORY button
indicator light goes out.
• The following message
appears on the display:
SYS-PGM No?
• The MEMORY button
indicator lights in red.
12-C-2
Comment/Note
• This is the "Initial display for
PITS station
programming mode".
• If the programming data of your
PITS is already accessed by
another system administration
device, the following message
appears on the display.
Already Accessed
• This is the "Initial display for
PITS system programming
mode".
• The password characters are
not displayed when you entered
for security reasons.
• If an incorrect password is
entered, an alarm tone will
sound.
• If the following message
appears, the system was
already accessed by another
administration device:
Already Accessed