Panasonic KX-TD500 System Reference Manual page 460

10.00 Operator Call
Description
Allow extension users to call the operator by
dialing the feature number for "Operator Call
(General)" or "Operator Call (Specific)".
Up to two operators are assignable for a system.
If Tenant Service is available, two operators are
assignable for each tenant, that makes four
operators available for a system.
If two operators are assigned in the system, or in
the tenant (if tenant Service is employed),
extension users can specify the operator (in the
same tenant) by dialing the feature number for
"Operator Call (Specific)".
Programming
System Programming
"System-Numbering Plan (9/11)",
Operator Call (Specific)
Operator Call (General)
Conditions
When calling an operator by dialing the feature
number for "Operator Call (General)", the
operator is selected according to the type of the
operators' stations as shown below:
Type of Station
Operator 1 Operator 2
ATT ATT
ATT EXT
EXT EXT
ATT —
EXT —
* The call which is made by the "Operator
Call (General)" arrives alternately to each
attendant console.
When no operators are assigned, a user hears
reorder tone during executing Operator Call.
For the assignment of operators, refer to Section
3-B-5.00 "Operator".
Reference
VT Dumb
10-D-6.09 11-C-11.00
Operator
Selected
Operator 1 or
Operator 2*
Operator 1 only
Operator 1 only
Operator 1 only
Operator 1 only
4-C-26
Operation
1. Lift the handset or press the SP-
PHONE button.
2. Calling an operator without
specifying
1) Dial the feature number for
"Operator Call (General)
(Default : 0)".
Calling an operator by specifying
1) Dial the feature number for
"Operator Call (Specific)
(Default : none)".
2) Dial "1" to specify operator 1.
Dial "2" to specify operator 2.
(Supplement)
• If your PITS has a display, the following
message appears on the display:
When the called operator is at an Attendant
Console:
ATT Console
When the called operator is at an extension:
<Example>
1000 : Mary
extension name
directory number