Panasonic KX-TD500 System Reference Manual page 889

6.00 REMOVE
Description
Enables you to delete the stored data by
specifying the devices. This operation should be
done before actually removing the devices.
This function is available in the screen where
"REMOVE" is displayed on the function field.
Operation
<Example>
Remove the programming data of an extension
with physical number 10101.
1. Press the F1 key.
1 SHOW LV 2 CHG LV 3 4 INS
2. Press the F6 key.
CMD>Remove Port No. (Physical No./DN xxxx/Ax)=
1 2 3 4
3. Enter the physical number 10101.
1 0
CMD>Remove Port No. (Physical No./DN xxxx/Ax)=10
1 2 3 4
4. Press the RETURN key.
CMD>Remove Port No. (Physical No./DN xxxx/Ax)=10101
* * * * *OK
1 2 3 4
• When the message below appears, the
programming data of physical number
10101 is deleted without failure.
*****OK
F1
5 OUS 6 REMOVE 7 EXIT 8
F6
5 6 7 EXIT 8
1 0 1
5 6 7 EXIT 8
RETURN
5 6 7 EXIT 8
Conditions
The system should be in On-line communication
mode.
The specified terminal should be "Out of Service"
or "Fault".
When it is impossible to execute "REMOVE"
operation, one of the following error messages
appears on the screen.
The error message type depends on the situation.
*****ERROR : Illegal parameter
*****ERROR : Parameter is not consecutive set
*****ERROR : Not installed
*****ERROR : Invalid status
*****ERROR : Parameter is empty
For details about the error messages, refer to
Section 10-K "Error Message Tables".
8-J-9