Panasonic KX-TD500 System Reference Manual page 444

4.02 Speed Dialing-System
Description
Allows any extension user to call outside parties
by simply pressing the AUTO button and dialing a
pre-assigned 3-digit code (001 to 200) common to
any extension user in the system. Up to 200
Speed Dialing Codes can be registered to the
system.
The Speed Dialing Codes are registered in
"System-Speed Dialing-System" screen, and toll
restriction level unique to each speed dialing code
can be assigned in the same screen.
Refer to "Toll Restriction Plan for System Speed
Dialing" on next page for further information.
If Tenant Service is employed, Speed Dialing
Codes can be divided by two tenants. In this
case, one tenant cannot use the Speed Dialing
Codes which belong to the other tenant.
Programming
System Programming
"System-Tenant", Speed Dialing-
System Boundary
"System-Speed Dialing-System",
Type, Dial
PITS System Programming
Storing Speed Dialing-System
Conditions
Each stored number can have up to 32 digits
including CO line access code. "0 to 9", "* ", "#",
"PAUSE", "FLASH", "—" and "SECRET" can be
registered.
A feature number for selecting a CO line must be
stored as leading digits.
The feature numbers for selecting a CO line are:
• Local CO Line Access
• Trunk Group 01-48 Access
The "Toll Restriction Plan for System Speed
Dialing" is valid when the extension user execute
the speed dialing with a PDN/SDN button.
Reference
VT Dumb
10-D-2.00 11-C-5.00
10-D-8.00 11-C-13.00
Reference
12-C-3.00
4-C-10
Operation
Calling an outside party using Speed Dialing-
System
1. Lift the handset or press the
SP-PHONE button.
• The indicator on the SP-
PHONE button lights in green.
• You hear dial tone 1, 3, or 4.
2. Press the AUTO button.
• The indicator on the AUTO
button lights.
• You hear no tone.
3. Dial the speed dialing code.
• The registered number is sent.
(Supplement)
Before pressing the AUTO button in step 2,
dialing a feature number for selecting a CO line
seizes the dialed CO line and starts outpulsing,
ignoring the feature number for selecting a CO
line registered in the speed dialing code.
Instead of the operation in step 1, pressing
Private CO, Single CO or Group CO ignores the
feature number for selecting a CO line stored in
the speed dialing codes and makes a call to an
outside party through the pressed CO line.
While dialing a speed dialing code in step 3,
canceling the code is possible by pressing the
AUTO button. Then repeat steps 2 to 3 for the
new entry.
One Touch Dialing, Speed Dialing, Last Number
Redial, Saved Number Redial and manual dialing
can be used in combination.
<Example>
An extension user can store a number consisting
of 33 digits or more by dividing it and storing it in
two speed dialing codes. In this case, a feature
number for selecting a CO line should not be
stored on the second speed dialing code.
To dial the number, first press the AUTO button
and dial the first speed dialing code, and then
press the AUTO button and dial the second
speed dialing code.