Panasonic KX-TD500 System Reference Manual page 988

Description of Assigning Items
1st through 12th Hundred Block
Extension
Conditions
"System-Numbering Plan" setting cannot be changed if "System-Operation",
Numbering Plan is set to "Fixed 1" or "Fixed 2." If "Flex" is selected, this setting is
changeable.
When entering "DG 1" to "DG 4", the cursor does not advance nor return automati-
cally. Use the and
this screen.
In any other setting screens than this screen, if you enter some data and press the
NEXT or PREV key without storing the data, the message "
Save OK ? >" appears on the screens. However, this screen advances or returns
without displaying the message.
Data storage is executed by the PF 4 (Memory) key or the PF 2 (End) key for all
screens at the same time, not respectively as other screens. Logical check is also
performed according to the following logic:
Extension numbers and other PBX extension numbers are three or four
digits and the leading one or two digits are assigned in "Numbering Plan"
screens.
Feature numbers may be one, two, three or four digits.
Those numbers assigned in Numbering Plan screens cannot include the
same number assigned to other feature number as the part or whole of it.
For example, if the digit "2" is assigned to the feature number for "Trunk
Group 01-08 Access" and another digits "21" is assigned for "Trunk Group
09-16 Access," it is checked at the time of data storage. Similarly, "35" and
"351" cannot be present at the same time.
It is possible to store "0" through "9", " ", "#", as the feature numbers.
However, if " " or "#" is included in the feature numbers, those features are not
accessed by the rotary telephone extensions.
Dials " #" are not available for feature numbers 1st to 12th Hundred Block
" and "
Extension.
When you have changed the Feature number of 1st~16th Hundred Block Exten-
sion and you have attendant consoles, you need to reset (making their status OUS
to INS, disconnecting the cable or resetting your PBX) them to refresh data of
them.
Assigns the leading one or two digits for extension DN (Directory
Number). If the leading digit is not programmed the DN assignment
is not possible.
keys to move the cursor. The BS key cannot be used in
10-D-38
Parameter