Auto Dialing - Panasonic KX-TD500 System Reference Manual

3.03 Remote Terminal with Modem

(Auto Dialing)

KX-TD500
1. Connect modem to the IBM-PC. (Please refer to the Operating Instructions of the modem.)
2. Execute modem communication software (terminal software).
3. Adjust the communication parameters as follows:
Parameter
Speed
Data Length
Parity
Stop Bits
Data Flow Control
Auto Wrap
Terminal Emulation
Capturing Data
File Receive / Send Protocol
Modem Initialize Command
Dial Prefix
4. Dial the number. The number differs depending on the remote access mode of the KX-TD500 as
follows:
A) Using DIL 1:1 to RMT
XXXXX
B) Using DISA
XXXXX , T XXXX
C) The other cases
Auto dialing is not available. Please refer to the procedure 7-B-3.04 "Remote Terminal with
Modem (Manual dialing)".
Modem
CO line
1200 bps
8 bits
None
1 bit
XON / XOFF
OFF
DEC VT100 or VT220
RAWASCII
ASCII Text
ATB1V1E0X1
ATDT (for DTMF Type Trunk),
ATDP (for Pulse Type Trunk)
Telephone number to call that CO line
RMT FDN (Default = 599)
Tone dial mode
Pause (More than one pause may be entered.)
Telephone number to call that CO line
RS-232C
Cable
IBM-PC
Default
7-B-6