9.06 Checking the Charge Meter–
CO Line
Used to check the charge meter of each CO line.
Operation
1. Set Charge Management
Mode.
2. Enter "2".
3. Enter CO line physical
number: 10101 through 31416
• To alternate between the rate
and the meter, press SELECT.
To check other CO lines:
4. Press PREV.
or
Press NEXT.
To finish the programming:
Display/Indicator/Tone
•
Charge Meter
•
CO No.?
<Example>
10101: 00005
10101: 00001.15DM
CO No.?
• The meter of the next CO line
physical number is displayed.
<Example>
10102: 00020
•
SYS–PGM No?
Initial Display of PITS Station
Programming Mode
13-C-43
Comment/Note
• Refer to Section 13-C-9.02
"Entering Charge
Management Mode".
• You can press NEXT to go to
the lowest CO line physical
number.
• The value of rate is valid only
the last 7 or 8 figures. Refer to
Section 11-C-58.02 "Charge
Rate (RAT)" for further
informations.
• Repeat steps 3 and 4.