Panasonic KX-TD500 System Reference Manual page 823

B. Administration
1.00 Introduction
Starting up the system administration can be
done using one of the following devices.
• DEC VT220 (VT100) Compatibles
• Dumb Terminal
• Attendant Console
Only one terminal can perform system
administration at any one time.
Starting up the system administration from a
remote location is available. For details about
Remote Operation, refer to Section 15-B-2.00
"System Administration from a Remote Location".
System Configurations
Three methods are available for system
administration as shown below.
System administration device is determined by
selecting the desired position of the SYSTEM
switch on the CPU board. (Refer to Section 2-F-
2.00 CPU Rotary-Switch Features.)
A. On-Site Administration
Main Unit
#1
RS-232C Cable
#2
Operation differs depending on whether the
terminal supports the DEC VT220 Emulation;
• DEC VT220 Compatible
(Refer to Section 8, 10 and 15)
• Dumb Terminal
(Refer to Section 9, 11 and 16)
B. Administration Using Attendant Console
Attendant
console #1
Attendant
console #2
Operation is the same as that of DEC VT220
Compatibles. (Refer to Section 8, 10 and 15.)
C. Remote-Site Administration
Main Unit
Operation differs depending on whether the
terminal supports the DEC VT220 Emulation;
VT220,
compatibles,
or Dumb
Terminal.
Remote-site administration is available even if
the SYSTEM switch on the CPU board is set to
any position. It is not available while the
selected device is administrating.
7-B-1
Extension
A
T
L
Extension
C
Modem
Central
Office
• DEC VT220 Compatible
(Refer to Section 8, 10 and 15)
• Dumb Terminal
(Refer to Section 9, 11 and 16)
Main Unit
Remote Terminal