Panasonic KX-TD500 System Reference Manual page 829

3.04 Remote Terminal with Modem
(Manual Dialing)
KX-TD500
1. Connect modem to the IBM-PC. (Please refer to the Operating Instructions of the modem.)
2. Execute modem communication software (terminal software).
3. Adjust the communication parameters as follows:
Parameter
Speed
Data Length
Parity
Stop Bits
Data Flow Control
Auto Wrap
Terminal Emulation
Capturing Data
File Receive / Send Protocol
Modem Initialize Command
Dial Prefix
4. Dial the number. The number differs depending on the remote access mode of the KX-TD500 as
follows:
A) Using DIL 1:1 to RMT
XXXXX
B) Using DISA
XXXXX [wait for DISA message] XXXX
C) Using Operator Transfer
ask the operator to be
XXXXX transferred to the RMT FDN
5. After hearing the modem tone, enter the answer command (ATD) and on-hook.
Modem
CO line
Tel Cable
SLT (which has DTMF dialing mode)
1200 bps
8 bits
None
1 bit
XON / XOFF
OFF
DEC VT100 or VT220
RAWASCII
ASCII Text
ATB1V1E0X1
ATDT (for DTMF Type Trunk),
ATDP (for Pulse Type Trunk)
Telephone number to call that CO line
Telephone number to call that CO line
Telephone number to call that CO line
RS-232C
Cable
IBM-PC
Default
RMT FDN (Default = 599)
wait for the
modem tone
7-B-7