Panasonic KX-TD500 System Reference Manual page 946

Relations between this screen and the other screens
• If no CO trunk card (LCOT, RCOT, PCOT, GCOT, DID) is assigned, "Trunk-CO
Line" screen cannot be selected.
• If no Extension card (PLC, SLC, MSLC, HLC, OPX, DLC, DHLC, ESLC) is as-
signed, "Extension-Station" screen cannot be selected.
• If AGC card is not assigned, "Trunk-AGC" screen cannot be selected.
• If DPH card is not assigned, "Extension-Doorphone" screen cannot be selected.
• If ATLC card is not assigned, "Extension-Attendant Console" screen cannot be
selected.
• If DISA card is not assigned, "Special Attended-DISA" screen cannot be selected.
• If DID card is not assigned, "Special Attended-DID" screen cannot be selected.
When deleting or changing the card assignment
• When deleting (selecting blank) or changing the pre-assigned card type, the
conditions should be the followings:
— The card status is OUS or Fault.
— All of the port data has been deleted.
However, if there exist port data, it is possible to change the cards as follows:
— PLC card
— SLC card
• Deleting the ATLC card will be an error if there is one of the following assignments:
— "Group-Trunk Group",
Incoming Mode (Day) is set to "ATT".
Intercept Routing (Day) is set to "ATT".
— "Extension-Doorphone",
Doorphone Call Assignment is set to "ATT".
• Deleting the DISA card will be an error if there is one of the following assignments:
— "Group-Trunk Group",
Incoming Mode (Day) is set to "DISA".
Incoming Mode (Night) is set to "DISA".
• Deleting the HLC, SLC, MSLC, DHLC, ESLC, LCOT, RCOT or GCOT card will be
an error if there is the following assignment to the slot to be deleted:
— Miscellaneous-Power Failure Transfer Assignment.
T-1/E-1 card
• T-1/E-1 card should be assigned to the Free Slot No. 1, 5 or 9.
• One T-1/E-1 card occupies two slots. If you assign a T-1/E-1 card to FS01, FS02
are not available for other card. For example, if you assign a T-1/E-1 card to FS01,
FS02 is not available for other cards. '—' (hyphen) is displayed and the cursor
skips them.
• If you have already assigned another card to an even slot, T-1/E-1 card is not
available to assign to the slot before it. For example, if you have already assigned
PLC card to FS02, you cannot assign a T-1/E-1 card to FS01.
Function
The following functions appear on the function line of this setting screen.
1 COMMON 2
COMMON (SHOW LV, CHG LV, INS, OUS, REMOVE, EXIT) and HRD CPY keys
are available in this setting screen.
For operation, refer to Section 8-I "Operation of Function Keys".
HLC card
HLC card
3 4 5 6 HRD CPY 7
10-C-6
8